Insert table: 6 rows, 5 columns table
 Right click table > Properties > Table Change settings:
Cell spacing = 1, Cell padding = 1 APPLY OK
 COLUMN 1: Merge all cells vertically to make one long bar
(How to do: Drag to highlight-hold down mouse button and pull through all cells in the column. Then right click, merge cells.) Change cell color to black. Change width to 8 pixels (place mouse on edge of column until it turns double headed, then drag the column guide bar to the left until you see 8 pixels shown in the lower left corner of your screen.)
 COLUMN 5: Repeat the same as column 1
 COLUMN 2: Change column width to 192 pixels. Change the 4th cell color to black
 COLUMN 4: Repeat the same as column 2
 Insert test into the black boxes. Note: to keep box from becoming HUGE, after the large lettering, change font size to 12 before pressing enter key.
 COLUMN 3: The small block between the black boxes, change the cell color to white. If you want this block to be spaced wider, just move the column to how wide you want it.
You should have something similar to diagram 1.
 ROW 1: Merge columns 2, 3, 4 into one long cell. Change cell color to black. Change the font in this cell to Arial 5 (type that number in since it is not on the list) to make the row thinner.
 ROW 6: Repeat the same as row 1
 ROW 2: Merge columns 2, 3, 4 into one long cell. Change cell color to white. Insert car photo center image
 ROW3: Highlight columns 2,3, 4 then change cell color to white. Insert the image and text
 ROW 5: Merge columns 2, 3, 4 into one long cell. Change cell color to white. Insert text.
You should have something similar to diagram 2.
 Right click table > Properties > Table Change settings: make the inside and outside border invisible:
 Project complete.
|